Hitachi VK-S454ER User Manual page 35

12.3 Installation Steps taking ceiling mount as an example
1. Open the package, and take out the camera and accessories.
2. Drill an installation hole in the ceiling with its diameter bigger than 236mm slightly (The ceiling support intensity shall be considered;
A bracket is necessary sometimes to increase the support intensity).
3. Rotate clockwise and open the ornament cover components; then
remove them. As shown in figure 11
4. Referring to the table 2, set the camera protocol and baud rate by the coding switch as shown in figure 6.
Check if the camera address is compatible with the address that you want; if not, set the camera to
corresponding address as per table 1.
5. Install the bracket components into the installation hole, fasten the screws to fix the bracket; clockwise
rotate and fasten the transparent cover, and then anticlockwise rotate the ornament cover components to
install them, as per figure 12.
anticlockwise
Anticlockwise rotate the transparent cover
components
Rotate clockwise and open the ornament cover
components
Figure 11
High Speed Dome Camera User's Manual
rotate the transparent cover components, and
Coding switch
- 35 -