Save These Instructions - Magnum Energy MM Series Owner's Manual

Terminology
AC source or External AC power - refers to Alternating Current (AC)
provided by the utility electric power grid or from a generator. In some
applications this is referred to as shore power.
AE application - typically refers to using the inverter in an system that
uses Alternative Energy (e.g., solar, wind, or hydro). This term is also
used to refer to inverters used in a home, offi ce, or a cabin installation.
Mobile application - refers to inverters used in a Recreation Vehicle
(RV), boat, or a truck installation.
IMPORTANT PRODUCT SAFETY INSTRUCTIONS
This manual contains important safety instructions that must be fol-
lowed during the installation and operation of this product. Read all
instructions and safety information contained in this manual before
installing or using this product.
• All electrical work must be performed in accordance with local, state,
and federal electrical codes.
• This product is designed for indoor/compartment installation. It must
not be exposed to rain, snow, moisture, or liquids of any type.
• Use insulated tools to reduce the chance of electrical shock or
accidental short circuits.
• Remove all jewelry such as rings, watches, bracelets, etc., when
installing or performing maintenance on the inverter.
• Always disconnect the batteries or energy source prior to installing
or performing maintenance on the inverter. Live power may be pres-
ent at more than one point since an inverter utilizes both batteries
and AC. Turning off the inverter may not reduce this risk. As long as
AC power is connected, it will pass thru the inverter regardless of the
ON/OFF power switch setting.
• Always verify proper wiring prior to starting the inverter.
• Do not operate the inverter if it has been damaged.
• Do not dismantle the inverter; there are no user-serviceable parts
contained in this product. Attempting to service the unit yourself
could cause electrical shock. Internal capacitors remain charged after
all power is disconnected.
• No AC or DC disconnects are provided as an integral part of this
inverter. Both AC and DC disconnects must be provided as part of
the system installation.
• No overcurrent protection for the battery supply is provided as an
integral part of this inverter. Overcurrent protection of the battery
cables must be provided as part of the system installation.
• No overcurrent protection for the AC output wiring is provided as an
integral part of this inverter. Overcurrent protection of the AC output
wiring must be provided as part of the system installation.

SAVE THESE INSTRUCTIONS

© 2010 Magnum Energy, Inc.
ii