Important Safety Instructions; Save These Instructions - Magnum Energy MicroGT 500 Owner's Manual

Safety Instructions

IMPORTANT SAFETY INSTRUCTIONS

This manual contains important instructions to follow during the
installation and maintenance of your MicroGT 500 inverter. To
reduce the risk of electrical shock and ensure the safe installation
and operation of the MicroGT 500, the following symbol appears
throughout this document to indicate dangerous conditions and
important safety instructions.
WARNING: This indicates a situation where failure to
follow instructions may cause a serious hardware failure or
personnel danger if not applied appropriately. Use extreme
caution when performing this task.
• Do NOT disconnect the PV module from the MicroGT 500 inverter
without fi rst disconnecting the AC power.
• Only qualifi ed professionals should install and/or replace the
MicroGT 500 microinverters.
• All electrical work must be performed in accordance with local,
state, and federal electrical codes.
• Before installing or using the MicroGT 500, please read all
instructions and cautionary markings in the technical documents
and on the MicroGT 500 inverter system and the PV array.
• Be aware that the body of the MicroGT 500 inverter is the heat
sink and can reach high temperatures. To reduce risk of burns,
do not touch the body of the MicroGT 500.
• Use insulated tools to reduce the chance of electrical shock or
accidental short circuits.
• Remove all jewelry such as rings, watches, bracelets, etc., when
installing or performing maintenance on the microinverter.
• Always verify proper wiring prior to energizing the microinverter.
• Do not operate the microinverter if it has been damaged.
• No AC disconnect is provided as an integral part of this
microinverter. An AC disconnect must be provided as part of the
system installation.
• No overcurrent protection for the AC output wiring is provided as
an integral part of this microinverter. Overcurrent protection of
the AC output wiring must be provided as part of the installation.
• Do NOT attempt to repair the MicroGT 500 inverter. If it fails,
contact Sensata Customer Support (425-353-8833) to obtain an
RMA number and to start the replacement process. Damaging or
opening the MicroGT 500 inverter will void the warranty.

SAVE THESE INSTRUCTIONS

iv
© 2016 Sensata Technologies