Sas Controller Option - HP PROLIANT ML330 G6 User Manual

Install the capacitor pack.
8.
Route the cable.
9.
Install the access panel (on page 22).
10.
Do one of the following:
11.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 20).
12.

SAS controller option

To install the component:
Power down the server (on page 20).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 21).
o
Remove the access panel (on page 21).
3.
Remove the expansion slot cover
4.
Install the SAS controller
5.
Disconnect the SATA cable from the hard drive backplane and from the system board.
6.
Connect the SAS cable to the hard drive backplane and to the SAS controller.
7.
Install the access panel (on page 22).
8.
Do one of the following:
9.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 20).
10.
("Open or remove the tower
("Removing the expansion slot
("Installing expansion boards" on page 64).
bezel" on page 20).
cover" on page 63).
Hardware options installation 72