Operations; Power Up The Server; Power Down The Server; Open Or Remove The Tower Bezel - HP PROLIANT ML330 G6 User Manual

Operations

Power up the server

To power up the server, press the Power On/Standby button.

Power down the server

WARNING:
equipment, remove the power cord to remove power from the server. The front panel Power
On/Standby button does not completely shut off system power. Portions of the power supply
and some internal circuitry remain active until AC power is removed.
IMPORTANT:
Back up the server data.
1.
Shut down the operating system as directed by the operating system documentation.
2.
NOTE:
step.
Press the Power On/Standby button to place the server in Standby mode. When the server activates
3.
Standby power mode, the system power LED changes to amber.
IMPORTANT:
panels. In a rack environment, this feature facilitates locating a server when moving between
the front and rear of the rack.
Disconnect the power cords.
4.
The system is now without power.

Open or remove the tower bezel

This server has a removable bezel that must be unlocked and opened before accessing the front panel
components. The bezel should remain closed during normal server operations.
CAUTION:
key.
CAUTION:
side.
To remove the component:
Power down the server (on page 20).
1.
To reduce the risk of personal injury, electric shock, or damage to the
If installing a hot-plug device, it is not necessary to power down the server.
If the operating system automatically places the server in Standby mode, omit the next
Pressing the UID button illuminates the blue UID LEDs on the front and rear
To avoid injury, HP recommends that only authorized technicians keep the bezel
To avoid breaking the bezel, remove the bezel before placing the server on its
Operations 20