Expansion Hard Drive Cage Option (Non-Hot-Plug) - HP PROLIANT ML330 G6 User Manual

The server is not shown for clarity.
Do one of the following:
8.
If using a SATA/SAS RAID controller, install the controller
o
page 64).
If using SATA cables, connect the cables to the system board, and then proceed to step 10.
o
Connect the SATA controller cable to the RAID controller.
9.
Connect the hard drive data cable to a hard drive backplane connector on the system board
10.
("System board
CAUTION:
unless all bays are populated with either a component or a blank.
Install any hard drives or blanks
11.
Install the air baffle.
12.
Install the access panel (on page 22).
13.
Do one of the following:
14.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 20).
15.

Expansion hard drive cage option (non-hot-plug)

To install the component:
Power down the server (on page 20).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 21).
o
Remove the access panel (on page 21).
3.
components" on page 11).
To prevent improper cooling and thermal damage, do not operate the server
("SAS or SATA hard drive
("Installing expansion
option" on page 52).
("Open or remove the tower
Hardware options installation 55
boards" on
bezel" on page 20).