Hp Trusted Platform Module Option - HP PROLIANT ML330 G6 User Manual

Using a T-15 Torx screwdriver, secure the dedicated iLO 2 management port module.
6.
Install the access panel.
7.
Do one of the following:
8.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Connect a network cable to the module, as needed.
9.
Power up the server (on page 20).
10.

HP Trusted Platform Module option

Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
Installing the Trusted Platform Module board (on page 75).
1.
Retaining the recovery key/password (on page 76).
2.
Enabling the Trusted Platform Module (on page 77).
3.
Enabling the TPM requires accessing the ROM-Based Setup Utility (RBSU)
Utility" on page 85). For more information about RBSU, see the HP website
(http://www.hp.com/support/smartstart/documentation).
TPM installation requires the use of drive encryption technology, such as the Microsoft® Windows®
BitLocker™ Drive Encryption feature. For more information on BitLocker™, see the Microsoft website
(http://www.microsoft.com).
CAUTION:
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
•
Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
Always observe the guidelines in this document. Failure to follow these guidelines
("HP ROM-Based Setup
Hardware options installation 74