Hardware Options Installation; Introduction; Processor Option - HP PROLIANT ML330 G6 User Manual

Hardware options installation

Introduction

If more than one option is being installed, read the installation instructions for all the hardware options
and identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.

Processor option

The server supports single- and dual-processor operation. With two processors installed, the server
supports boot functions through the processor installed in processor socket 1. However, if processor 1
fails, the system automatically boots from processor 2 and provides a processor failure message.
WARNING:
internal system components to cool before touching them.
CAUTION:
• Do not touch the processor socket contacts.
• Always install the processor socket cover after removing the processor from the socket.
• Do not tilt or slide the processor when lowering the processor into the socket.
CAUTION:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.
CAUTION:
multiprocessor configurations must contain processors with the same part number.
CAUTION:
a processor and a heatsink or a processor socket cover and a heatsink blank.
CAUTION:
heatsink is removed from the processor after it has been installed.
CAUTION:
multiprocessor configurations must contain the same type of processors.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To avoid damage to the system board:
To avoid damage to the processor:
To prevent possible server malfunction and damage to the equipment,
To prevent possible server overheating, always populate processor socket 2 with
The heatsink thermal interface media is not reusable and must be replaced if the
To prevent possible server malfunction and damage to the equipment,
Hardware options installation 35