Memory Options - HP PROLIANT ML330 G6 User Manual

Be sure the airflow arrow on the heatsink points toward the rear of the server.
(Optional) To optimize performance, install DIMMs into the processor 2 DIMM slots
20.
DIMMs" on page 47).
For the location of the processor 2 DIMM slots, see "System board components (on page 11)."
Install the air baffle.
21.
Install the access panel (on page 22).
22.
Do one of the following:
23.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Connect all power cords to the server.
24.
Connect power cords to the power source.
25.
Power up the server (on page 20).
26.

Memory options

IMPORTANT:
these two types causes the server to halt during BIOS initialization.
The memory subsystem in this server can support RDIMMs or UDIMMs. Both types are referred to as
DIMMs when the information applies to both types. When specified as RDIMM or UDIMM, the
information applies to that type only. All memory installed in the server must be the same type.
The server supports the following DIMM speeds:
•
Single- and dual-rank PC3-10600 (DDR-1333) DIMMs operating at 1333 and 1066 MHz
•
Quad-rank PC3-8500 (DDR-1067) DIMMs operating at 1066 MHz
Depending on the processor model, the number of DIMMs installed, and whether UDIMMs or RDIMMs
are installed, the memory clock speed may be reduced to 1066 or 800 MHz. For more information on
the effect of DIMM slot population, see "General DIMM slot population guidelines (on page 43)."
This server does not support mixing RDIMMs and UDIMMs. Attempting to mix
("Installing
Hardware options installation 40