Installation - Harman PC45 Installation & Operating Manual

Installing
Place the stove on a noncombustible floor or floor protector that extends a
minimum of 6" (152mm) to the front of the load door opening, 6" (152mm)
to the sides of the door opening, and 6" to the rear. Floor protection must
also extend 2" (51mm) beyond each side of any horizontal flue pipe. The
minimum floor protector material is 20 gauge sheet metal. Other floor
protector materials are ceramic tile, stone, brick, etc.
NOTE for Canadian installation only: Per ULC-S627-00, If installed
on a combustible floor, the need to provide a noncombustible floor
protector covering the area beneath the space heater and extending
at least 17.72" (450mm) on the firing side and at least 7.87" (200mm)
on the other sides.
In Canada, you may follow smaller U.S. floor protection
requirements ONlY if the user agrees to completely shut-down
the appliance, and allow it to cool to where all fire is extinguished
and the combustion blower and its indicator light shuts off, prior
to opening the firebox door or ash door.
Place the stove away from combustible walls at least as far as shown in
Figures 3 and 4. Please note the difference in side wall clearance with
and without side shields.
Note that the clearances shown are minimum for safety but do not leave
much room for access when cleaning or servicing. Please take this into
account when placing the stove.
Connect the power cord to a 120 VAC, 60 Hz grounded receptacle. (A
surge protector is recommended to protect the circuit board.) Also be
sure that the polarity of the outlet that the stove is plugged into is correct.
Prior to installing the flue pipe, connect a draft meter. (The draft meter
must have a minimum range of 0 - .5") Record the first reading. Connect
flue pipe to stove and be sure all doors and windows in the home are
closed. Record the second draft reading_______. If the second reading is
more than .05" lower than the first reading, check for possible restrictions
or the need for outside air. For more information on the draft test
procedure, refer to the draft adjustment procedure located in this manual.
mobile home Installation
When installing this unit in a mobile home, several requirements must
be followed:
1. The unit must be bolted to the floor. This can be done with 1/4" lag
screws through the 2 holes located in the base plate.
2. The unit must also be connected to outside air.
3. Floor protection and clearances must be followed as shown.
4. Unit must be grounded to the metal frame of the mobile home.
CAuTION: This appliance must be vented to the outside.
Due to high temperatures, the stove should away from traffic, furniture
and draperies.
Children and adults should be alerted to the hazards of high surface
temperatures and should stay away to avoid burns to skin and/or clothing.
Young children should be carefully supervised when they are in the
same room as the stove.
Clothing and other flammable materials should not be placed on or
near this unit.
!
ThE STruCTurAl INTEgrITY OF ThE
mANuFACTurEd hOmE FlOOr, wAll, ANd CEIlINg/
rOOF muST bE mAINTAINEd.
dO NOT INSTAll IN SlEEPINg rOOm.
3-90-02686R29_05/14

Installation

WARNING
Alternate floor protector
d i m e n s i o n m a y b e u s e d
as long as they satisfy the
9"(228mm)-
measurement requirements
shown below.
13"(330mm)
Minimum size floor protection
for a corner installation 3
pad is 36" x 36". Clearance
shown as 9" with optional side
shields installed.
9"(228mm)With Side Shields
13"(330mm) Without Side Shields
Fig. 3
14" (355mm) with
side shields
18" (457mm)
without side shields
Fig. 4
Minimum size rectangular floor protection (USA) is
28 " Deep By 24 " Wide.
5/16 3/4
*Floor protection dimensions for the front and sides are
measured from the appliance door opening in The United
States. In Canada, the side dimension is measured from the
widest part of the appliance.
Floor Protection
requirements
j Sides
K
Front
l
Rear
NOTE:
Measurement "L" is
measured from the
pedestal base in
the US ONLY
NOTE:
Measurement "K"
is measured from
the glass in the US
ONLY
j
uSA
2"(51mm)
14" (355mm)
18" (457mm)
36"(914mm)
US
Canada
6" 200mm
6" 450mm
6" 200mm
l
CANAdA
K
F
loor protector
PC 45 Corn/Pellet Stove
j
4