Harman PC45 Installation & Operating Manual page 27

Optional Trim
There are three different finishes to choose from, gold,
brushed stainless, and bright nickel. Each trim kit includes a
door frame, a drill bit for the load door holes, an ash door tile
trim, and an ash fender trim. The ash door tile frame can be
installed with or without the decorative tile. Fig. 41.
To install the door frame, lay the frame face down on a soft
surface. Fasten door frame by inserting the 4 threaded posts
on the frame through the door. The posts should line up with
the 4 holes located at the corners of the door. Once the posts
are through the door, fasten frame with 4 nuts and tighten
until the frame is snug.
To install ash lip trim, simply slide the trim over the ash lip
and into the groove on the trim.
The ash door frame includes a bent spring clip. Insert the
spring clip into one end of the frame. Start the frame into the
recessed area of the ash door with the clip end first. Push
tension on the spring clip while inserting the other end of the
frame into the recess.
decorative Tile
Decorative tile is available in four choices of slate or a
brushed stainless deer cutout (shown below). The tile installs
behind the trim on the ash door.
Fig. 41
27 pC 45 Corn/pellet Stove
Options
Cleaning Plated Trim
Gold or nickel plated hardware should never be buffed or
polished. Abrasive cleansers and metal polishes will remove
the plating and therefore should never be used. If the plating
needs to be cleaned, wait until the stove is completely cool,
then use a sponge, soap and water to gently remove dirt and
stains. Before relighting the stove, remove all soap residue
and wipe dry.
direct vent wall Pass-through
The direct vent wall pass-through allows you to bring outside
air in for combustion, and safely pass your pellet venting
through the wall while only needing to make one hole. The
pass through is adjustable for different wall thickness from
4½" to 10⅛" thick. Item # 1-00-677077 is compatible with 3"
venting only.
Optional hopper Screen (Corn Strainer)
The hopper screen/corn strainer was designed to sift the corn
as it is loaded into the hopper. This sifting will catch unwanted
materials from being burned. The strainer also includes a
removable funnel to aid in fuel handling.
burnpot grates
The PC45 includes two burn grates. You'll notice that they
each have different sized air holes in them. Use the grate that
fits your fuel the best. In most cases, the smaller holes will
be best with corn and the large holes will be best for pellets.
Feel free to experiment with both grates.
Outer half
Inner half
3-90-02686R29_05/14