Assembly & Installation - Harman XXV Installation & Operating Manual

Flame guide
Install the cast iron flame guide on top of the burn
pot. Make sure that the flame guide is fully seated on
the vertical sides of the burn pot and that the back of
the guide rests against
the burn pot mounting
flange.
install the exhaust
/ v e n t i n g a t t h e
clearances specified
b y t h e v e n t i n g
manufacturer. Some
brands of pellet venting
require a " clearance
to combustibles, while
other brands require
only one inch.
dO nOt inStall a Flue daMPer in the
eXhauSt Venting SYSteM OF thiS unit.
dO nOt cOnnect thiS unit tO a chiMneY
Flue SerVing anOther aPPliance.
cautiOn
hOt while in OPeratiOn. keeP
children, clOthing and Furniture
awaY. cOntact MaY cuaSe Skin
burnS.
4
XXV Pellet Stove
iMPOrtant nOteS
assembly and installation
Figure 1
The power cord is tucked inside the left rear cover
panel. To remove cord, Loosen the two 5/16" hex
heads and slide the panel outward.
cautiOn
keeP cOMbuStible MaterialS (Such
aS graSS, leaVeS, etc.) at leaSt 3
Feet awaY FrOM the Flue Outlet
On the OutSide OF the building.
Due to high temperatures, the stove should be
placed out of traffic and away from furniture and
draperies.
Children and adults should be alerted to the haz-
ards of high surface temperatures and should stay
away to avoid burns to skin and/or clothing.
Young children should be carefully supervised
when they are in the same room as the stove.
Clothing and other flammable materials should
not be placed on or near this unit.
Installation and repair of this Harman stove
should be done by a qualified service person. We
recommend that the stove be inspected before use
and at least annually by a qualified service person.
Periodic cleaning is required throughout the heat-
ing season and at the end of each winter for the
stove to work efficiently. See cleaning instructions
on page .