Assembly & Installation - Harman PC45 Installation & Operating Manual

Rear Cover
Panel
Shipping bolts
Note: These same holes are used for
securing the stove in mobile home
installation.
Fig. 1
Follow these instructions along with all local codes regarding
installation of this appliance.
Do NOT use makeshift compromises when installing this
appliance, serious consequences may result.
With any hearth appliance, installation of smoke detectors
is recommended on every level of the home.
Possible causes of smoke detector activation:
Paint curing process - Open a window near the appliance
for the first few hours of burning.
Exhaust being drawn back inside the dwelling - Outside air
connection to the appliance is necessary.
Vent leakage - All interior seams and joints should be sealed
with silicone where applicable. Follow vent manufacturers
instructions for proper sealing.
3 pC 45 Corn/pellet Stove
Assembly and Installation
Rear Cover
Panel
unpacking
The PC 45 is bolted to the skid to prevent movement during
shipping.
To free the stove from the skid you must remove the hold-
down bolts in the rear of the pedestal base.
removing or Installing rear panels
To remove the rear cover panels, loosen the screws slightly
and slide the covers outward as shown in Fig 1. To reinstall,
simply slide back into place and retighten the screws.
If needed, install the (2) 5/16-18 X 3/4" leveling bolts located
in the hardware kit. Fig 1.
Firebrick
Install the three (3) firebrick vertically on the angle above
the burnpot. Fig. 2
Fig. 2
3-90-02686R29_05/14