Harman PC45 Installation & Operating Manual page 15

MAX.
CORN
Fig. 21
!
dO NOT CONNECT TO ANY AIr dISTrIbuTION
duCT Or SYSTEm.
dO NOT burN gArbAgE Or FlAmmAblE FluIdS
SuCh AS gASOlINE, NAPThA, Or ENgINE OIl.
hOT whIlE IN OPErATION. KEEP ChIldrEN,
ClOThINg, ANd FurNITurE AwAY. CONTACT mAY
CAuSE SKIN burNS.
KEEP FIrEbOX ANd ASh rEmOvAl dOOrS
ClOSEd durINg OPErATION. mAINTAIN SEAlS IN
gOOd CONdITION.
15 pC 45 Corn/pellet Stove
Automatic Start up
4
3
TEST
CAUTION
Starting the Fire
Igniter Switch to "AuTO" (up position)
Make sure the unit is plugged into a 120 VAC, 60 Hz
electrical source. The power light should be the only light lit.
Anytime there is an interruption in power at the receptacle,
the combustion blower will run for 1 minute after the power
is restored. The control uses this time to determine exhaust
temperature and if there is a need to remain on.
bE SurE ThErE IS NO FuEl Or OThEr COmbuSTIblES
IN ThE ASh PAN PrIOr TO lIghTINg.
1. Turn the Mode Selector to "OFF"
2. Fill the hopper with corn or pellets.
3. Clean the burn pot and housing, if necessary.
4. If starting after an empty hopper, turn the feed adjuster to
"TEST" until the fuel is visible in the auger tube opening.
Fig 21, This also allows you to check the motors for
operation.
NOTE: The auger motor will not operate with the view door
or ash door open.
NOTE: The initial start-up on a new stove may require the
corn to be purged into the burnpot area before continuing
to step 5.
5. Turn the feed adjuster to #2 (corn) or #4 (pellet)
6. Flip the igniter switch up into the "AUTO" position.
7. Turn the temperature dial to the desired setting.
8. Turn the mode selector dial to Room Temperature or Stove
Temperature.
9. Fill the hopper with corn or pellets and remove the ashes
as required.
!
NEvEr uSE gASOlINE, gASOlINE-TYPE lANTErN
FuEl, KErOSENE, ChArCOAl lIghTEr FluId, Or
SImIlAr lIQuIdS TO STArT Or "FrEShEN uP " A
FIrE IN ThIS hEATEr. KEEP All SuCh lIQuIdS
wEll AwAY FrOm ThE hEATEr whIlE IN uSE.
WARNING
3-90-02686R29_05/14