Pellet Fuel Optimization - Harman PC45 Installation & Operating Manual

For optimal performance burning wood pellets, the pellet kit #1-00-06801 is now
included. This kit allows you to convert the PC45 into a fully automatic pellet stove
with 50,000 BTU capacity, fast ignition and clean viewing glass. Since there may be
changes needed for the circuit board programing, it is recommended that this installation
be completed by a trained service technician. Be sure the power cord is unplugged
prior to adjusting circuit board switches. The pellet kit contains the instructions for the
conversion, a new burn pot end gate, and a new combustion blower inlet ring.
This figure shows the corn burn pot
as installed from the factory.
The combustion blower inlet ring on the left is the one originally installed in the stove. Note the larger opening in the ring
on the right. This allows the PC45 to produce more heat when burning pellets. The larger ring does the opposite when
burning corn. If you want to switch back to corn or grain, exchange the inlet ring back to the smaller opening.
13 pC 45 Corn/pellet Stove

Pellet Fuel Optimization

This figure shows the new end gate
which gets installed without the
stirring rod.
This figure shows the pellet burn
pot after installing the new end
gate.
3-90-02686R29_05/14