Grain Cap Installation - Harman PC45 Installation & Operating Manual

grain Cap
The grain cap is designed to enhance the burn quality of the
fuel being burned (i.e. field corn, wheat, barley, rye, oats,
etc.) Its purpose is to reflect more heat into the burn pot.
This promotes a more thorough burning of the fuel and less
ash. Depending on the quality of the fuel being burned, the
effectiveness of the grain cap may vary.
The grain cap will need to be removed for cleaning. This part
is classified as a consumable item and is excluded from the
product warranty.
Installation:
1. Hook the slot on the grain cap over the lip on the side rail
of the burnpot, as shown.
2. Allow the grain cap to rest onto the burnpot sides.
burn Pot with Smaller holes
The PC45 stove is built with a burn pot that has .125 (1/8")
combustion air holes. This grate has no identifying marks.
Included with your stove is an additional grate that has .0625
(1/16") combustion air holes. This grate can be identified with
etchings on the bottom side. An 'S' is etched on one end and
'724208' is etched at the other end.
Depending on the type and the moisture content, some corn
or grain will burn better with the smaller holes for combustion
air, while others may work better with the larger holes.
To change the burn pot grate, first remove the end gate
retainer and the end gate. Pull the auger extension from the
auger, and lift the grate out of the frame. Place the new grate,
install the auger extension, replace the end gate and retainer
clip. Refer to the diagrams on the next page for guidance.
3-90-02686R29_05/14

grain Cap Installation

Fig. 18
You may opt to change the burn
pot to this version with smaller
holes. This option has the letter
"S" marked on it. Part # 1-10-
724208.
Burn Pot
PC 45 Corn/Pellet Stove
Grain Cap
The PC45 is built with this burn pot
that has larger holes, Part #1-10-
724108.
12