HP NetServer LC 2000r Installation Manual page 83

Chapter 7
NOTE Some processor speeds listed in Table 7-1 may not be supported. For the
latest support information, visit the HP web site:
http://www.hp.com/go/netserver
NOTE
The System board is shown removed from the HP NetServer
for simplicity in the following figures, but it is not necessary to
remove the system board to install the new processor module
or the VRM.
8. Loosen the thumbscrew on the processor cage cover, and lift off the cover
as shown in Figure 7-3.
Processor Cage
Cover
Figure 7-3. Removing Processor Cage Cover
Installing Additional Processors
75