HP NetServer LC 2000r Installation Manual page 66

Chapter 5
5. Insert the DIMM fully into the slot, handling the DIMM by its edges. See
Figures 5-2 and 5-3.
The retaining clips should grasp the DIMM automatically if it is inserted
properly. If the clips do not close, the DIMM is not inserted correctly.
CAUTION
Do not rock the DIMM into place, but apply firm and even
pressure. If the retaining clips do not close, remove the DIMM
and repeat Steps 2-5.
NOTE
The Processor Cage Cover is shown removed for clarity.
6. If all DIMMs have been installed, replace the cover.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
58
Figure 5-3. Installing the DIMM
Installing Additional Memory