Hot Swap Configuration Options - HP NetServer LC 2000r Installation Manual

Chapter 4
If there are gaps in the cage, the drives may not receive the proper
ventilation and could suffer thermal damage.
Filler Panels and Spacers
Ensure all empty slots in the Hot Swap drive cage have filler panels
inserted to ensure proper airflow.
If there are fewer drives than the Hot Swap drive cage supports, a
1-inch filler panel must be inserted in each empty disk location. The
filler panels ensure the drive cage has the proper ventilation and
airflow. The filler panel will be removed before inserting a new drive.
Ensure all smaller spaces in the Hot Swap drive cage have the smaller
filler panels inserted to ensure properly airflow.
If there is a mix of 1-inch and 1.6-inch drives in the drive cage, you
may need to add ½-inch drive spacers. The smaller drive spacer fills the
gap between adjacent drives or between a drive and a filler panel. Disk
spacers can be mounted on 1-inch low-profile drives or 1.6-inch
half-height drives, so a drive spacer and low-profile drive are the same
size as a half-height drive, and a drive spacer and a half-height drive
are as large as two low-profile drives.
CAUTION
To prevent overheating or excessive electromagnetic
radiation, use the filler panels and spacers to fill the gaps
between Hot Swap hard drives. If the filler panels or spacers
are left out of the drive shelves, thermal damage and/or
excessive EMI could occur.
Hot Swap Drive Cage Configurations
The possible Hot Swap Drive Cage Configurations are summarized in
Figures 4-2 through 4-5 for the HP NetServer's LC 2000r and LC 2000
respectively. There are various SCSI cable configurations associated with
the system and, if incorrectly configured, could cause damage to the HP
NetServer and the SCSI devices. Refer to Figures 4-6 and 4-7.

Hot Swap Configuration Options

The Hot Swap Mass Storage Cage has various configurations which affects the
options installed and cable configurations. If the Duplex board is installed on the
mass storage cage, the drive and cable configurations differ from those shown
without the duplex board installed. Compare Figures 4-2 and 4-4 or 4-3 and 4-5.
38
Installing Mass Storage Devices