Table of Contents
Advertisement
Frequently asked questions & troubleshooting (cont.)
If heat pump issues cool air
in heat mode or warm air in
cool mode
If heating system is
running in cool mode
If Zone Temperature reads
"40"
If you cannot change system
setting to cooling
Product specifi cations
Temperature Range
Differential
Input Power
Output Power
Wireless Type
Wireless Range
Operation Temperature
Shipping Temperature
Operating Humidity
Physical dimensions
FCC compliance
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Modifi cations not expressly approved by the manufacturer could void the user's authority to operate
the equipment under FCC rules. NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
© COPYRIGHT 2010 PECO, INC. ALL RIGHTS RESERVED. P/N 70161 3220-2216 Rev 0
WavePRO is a trademark, and PECO is a registered trademark of PECO, Inc. The PECO logo is a trademark or servicemark of PECO, Inc.
• Check SYS menu
properly confi gured for your system (see p.14,
confi
guration").
• Check SYS menu
heating and cooling equipment.
• Ensure R2500 is wired properly (see p.6,
examples").
• Verify that the R2500 receiver LED is continuously lit
(See "WavePRO Wireless System Operating Manual").
• Verify that the intended temperature source is defi ned
(See SYS menu 42).
• Check SYS menu
heating and cooling equipment.
50° to 90° F (10° to 32° C)
1° F (0.5°C)
T2500 Thermostat: Two AA alkaline batteries or 24 VAC, 50/60 Hz
R2500 Receiver: 24 VAC, 50/60 Hz
24 VA (Pilot Duty)
902 to 928 MHz Band, Frequency Hopping Spread Spectrum (FHSS)
100 feet (30.48 meters) typical reliable range in open air
0° to 120° F (-17° to 48°C)
-20° to 130°F (-28°to 54°C)
5% to 95% RH, non-condensing
T2500: 4.5"H x 5.75" W x 1.1"; D R2500: 4.8"H x 3.8"W x 1.3"D
Automation and Controls
Division of PECO, Inc.
PO Box 82189, Portland, OR 97282
52
to assure that reverse valve is
50
to assure that it is set to match your
50
to assure that it is set to match the
Phone: 503-233-6401
Email: sales@pecomanufacturing.com
www.pecomanufacturing.com
20
"Advanced
"R2500 wiring
Advertisement
Table of Contents
