Getting started
This booklet provides an installation guide, wireless pairing instructions, and advanced
confi guration options for the R2500 and T2500. Please note:
•
In order to establish correct pairing, the R2500 must be mounted and
wired before applying power to the T2500.
•
Read and understand the "Advanced confi guration" section to
determine your preferred settings on the T2500 before performing
wireless pairing.
WavePRO Wireless System pre-installation checklist
WavePRO Wireless System (T2500 and R2500) mounting considerations:
•
Locate the T2500 and R2500 within 100 ft. (30 m.) of one another.
•
Avoid locating devices within a metal enclosure or between large
obstructions.
•
The WavePRO Wireless System will communicate through walls and other
obstructions, but these may reduce the effectiveness of its operating range.
Required tools & supplies:
•
No. 2 Phillips screwdriver
•
Small fl athead screwdriver
•
Drill
•
Drill bit (3/16" for drywall, 7/32
for plaster)
PECO T2500 WavePRO
Wireless Thermostat
WavePRO Wireless System
Installation Guide
PECO R2500 Wireless
Receiver
© COPYRIGHT 2010 PECO, INC. ALL RIGHTS RESERVED. P/N 70161 3220-2216 Rev 0
•
Hammer
•
Pencil
•
Electrical tape
•
Level (optional)
•
Two new AA batteries
T2500 backplate
Wall anchors
WavePRO Wireless T2500 &
R2500 Operating Manual
3