Activating The Bsr Sewing Function; Deactivating The Bsr Sewing Function By Using The Start/Stop Button; Holding The Work; Bsr Function Deactivation - Bernina 820 Owner's Manual

activating the BSr Sewing function:

1. With the foot control
► plug in the foot control
► lower the presser foot
► start the BSR mode by pressing the foot control
► a red light appears on the presser foot
► the foot control must be pressed continuously during
sewing
► the speed of the sewing computer will be regulated by
the movement of the fabric
► by releasing the foot control the BSR mode stops
Deactivating the BSr Sewing function
by using the Start/Stop Button
mode 1:
► if the fabric is not moved for approx. 7 seconds, the
BSR mode is deactived and the red light on the presser
foot goes off
112
2. With the Start/Stop Button
► lower the presser foot
► start the BSR mode by pressing the Start/Stop Button
► a red light appears on the presser foot
► the speed of the sewing computer is regulated by the
movement of the fabric
► by re-pressing the Start/Stop Button the BSR mode
stops
mode 2:
► if the stitching process is ended by no longer moving the
fabric, one additional stitch is made depending on the
needle position. The sewing computer always stops with
the needle up, even if the arrow on the display points
down

Holding the Work

► hold and guide the taut fabric with both hands
► abrupt movements of the fabric (slowing down, speed-
ing up respectively) can result in slightly too short or too
long stiches
► continuous movement of the fabric (no abrupt move-
ments) under the foot will provide best results
► move the fabric in one direction for best results
application example:
BSr With Zigzag Stitch no. 2
► the zigzag stitch can be used for thread painting or
fabric embellishment for example
► areas can be filled and forms or pictures created

BSr function Deactivation

► pull out the plug of the BSR presser foot connection
cable on the sewing computer. The straight stitch no. 1
is active
► remove the BSR foot
032298.53.04_1204_B820_EN