Important Information
If a buttonhole is to be sewn at right angles to
a seam, we recommend the use of the height
compensation plates for buttonholes (available
as optional accessory).
Using the compensation plate is recommend-
ed when sewing buttonholes in difficult fabrics.
It can be used with the Automatic buttonhole
foot no. 3A or the buttonhole foot 3B.
preparation
thread tension
►
the tension is set automatically when a buttonhole is
selected
►
the upper tension is slightly looser than normal
►
this gives a slightly rounded appearance to the beads,
making the buttonhole more attractive
►
cord reinforces buttonholes and enhances their appea-
rance
►
sew both beads at the same speed
test Sewing
►
always sew a test sample on the fabric with stabilizer
you intend to use
►
select the buttonhole type you intend to use
►
sew the buttonhole in the same direction on the fabric
(with or against the grain)
►
cut the buttonhole open
►
push the button through
►
adjust the buttonhole length if necessary
corrections
to adjust the Bead Width
►
alter the stitch width
altering the Stitch Length
►
any alterations to the stitch length affect both beads
(more dense or less dense)
►
always reprogram the buttonhole after any changes to
the stitch length
manual Buttonholes
►
mark the buttonhole length in the desired position
►
use Buttonhole foot no. 3C (optional accessory)
automatic Buttonholes
►
mark the length of just one buttonhole
►
after sewing the first buttonhole, the length for all
subsequent buttonholes is automatically programmed
►
mark only the beginning of all subsequent buttonholes
►
use Automatic buttonhole foot no. 3A
032298.53.04_1204_B820_EN
99