Overcasting; Satin Stitch - Bernina 820 Owner's Manual

overcasting

With Zigzag Stitch no. 2
► guide edge of fabric into the center of the presser foot
► do not select too wide a width or too long a stitch – the
edge should lie flat and not roll
► needle goes into fabric on one side and over the edge
into the air on the other side
► use a fine darning thread for lightweight fabric

Satin Stitch

► dense stitch used for appliqué, embroidery, etc.
► shorten stitch length, satin stitch setting will be indicated
by parallel lines on stitch length bar
►
If edges roll:
►
The sewing computer has a programmed satin
stitch: no. 1354
032298.53.04_1204_B820_EN
Reverse pattern foot no. 1C
use the Vari-overlock stitch and foot
no. 2A (optional accessory)
93