preparation
►
use Slide-on table
►
attach the desired presser foot sole to the BSR Presser
Foot
‣
removing sole: press both buttons (see arrows) on
each side of the foot
‣
slide the sole down the groove at an angle
‣
attaching the sole: slide the sole up in the groove
until it clicks into place
Presser Foot Pressure may be reduced
depending on the fabric type and thickness.
►
attach the BSR Presser Foot to the sewing computer
and plug the cable in the outlet provided
►
the «BSR» screen opens automatically
►
the BSR mode 1 is activated (BSR1 is standard)
►
the basic stitch length setting is 2mm
►
set the desired stitch length
►
when sewing small forms and stippling, stitch length of
1mm - 1.5mm is suggested
032298.53.04_1204_B820_EN
109