Comtech EF Data KPA-020IN Installation And Operation Manual page 11

Ku-Band Solid-State Power Amplifier
Preface
European EMC Directive
In order to meet the European Electro-Magnetic Compatibility (EMC) Directive (EN55022,
EN50082-1), properly shielded cables for DATA I/O are required. More specifically, these cables
must be shielded from end-to-end, ensuring a continuous ground shield.
The following information is applicable for the European Low Voltage Directive (EN60950):
International Symbols:
Note: For additional symbols, refer to "Cautions and Warnings" listed earlier in this preface.
<HAR> Type of power cord required for use in the European Community.
CAUTION: Double-pole/Neutral Fusing
!
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
Alternating Current.
Fuse.
Safety Ground.
Chassis Ground.
ix
Revision 0
MN/KPA.IOM