Power Button; Chassis Intrusion; Universal Serial Bus (Usb0/1) - Advantech RS-200-RPS-D User Manual

Power Button

The Power Button connection is
located on pins 1 and 2 of JF2.
Momentarily contacting both pins
will power on/off the system. This
button can also be configured to
function as a suspend button (see
the Power Button Mode setting in
BIOS). To turn off the power
when set to suspend mode, de-
press the button for at least 4
seconds. Refer to the table on the
right for pin definitions.

Chassis Intrusion

A Chassis Intrusion header is lo-
cated at JL1. Attach the appropri-
ate cable to inform you of a chas-
sis intrusion.
Universal Serial Bus
(USB0/1)
Two Universal Serial Bus ports
are located beside the PS/2 key-
board/mouse ports.
bottom connector and USB1 is the
top connector. See the table on
the right for pin definitions.
Extra Universal Serial Bus
Headers
Extra USB headers can be used
for front side USB access.
will need a USB cable (not in-
cluded) to use either connection.
Refer to the tables on the right for
pin definitions.
USB0 is the
You
2-9
Chapter 2: Installation
Power Butto n
Connector
Pin Definitions
(JF2)
Pin
Number Definition
1 PW _O N
2 Ground
Universal Serial Bus Pin Definitions
USB0
Pin Pin
Number Definition Number
1 +5V 1
2 P0- 2
3 P0+ 3
4 Ground 4
5 N/A 5
Front Panel Universal Serial Bus Pin
Definitions
USB2/F PUSB0
Pin Pin
Number Definition Number
1 +5V 1
2 P0- 2
3 P0+ 3
4 Ground 4
5 N/A 5
USB1
Definition
+5V
P0-
P0+
Ground
Key
USB3/FPUSB1
Definition
+5V
P0-
P0+
Ground
Key