Pga Processor And Heatsink Installation - Advantech RS-200-RPS-D User Manual

2-2

PGA Processor and Heatsink Installation

When handling the processor package, avoid placing direct
pressure on the label area of the fan. Also, do not place the
!
motherboard on a conductive surface, which can damage the
BIOS battery and prevent the system from booting up.
IMPORTANT: Always connect the power cord last and always remove it
before adding, removing or changing any hardware components.
sure that you install the processor into the CPU socket before you install
the CPU heat sink.
1. Locate the following components, which are included in the shipping
package.
Clips (2)
Retention brackets
(2)
*These screws are for mounting the
motherboard to the back panel of a
chassis that has four mounting holes
(as shown on right).
For chassis that do not have four
mounting holes, use the anchor/peg
assemblies:
2. Insert the white pegs into the
black anchors. Do not force the
white pegs all the way in - only
about 1/3 of the way into the black
anchors.
3. Place a retention bracket in the
proper position and secure it by
pressing pegs into two of the retention
holes until you hear a *click*. The
clicking sound indicates that the peg is
locked and secured.
Screws* (4)
Black anchors (4)
White pegs (4)
Anchor/peg
assemblies
Two pegs in
position
One retention bracket in
position
2-2
Chapter 2: Installation
Make