Installing Dimms - Advantech RS-200-RPS-D User Manual

2-3

Installing DIMMs

CAUTION:
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Also note that the memory is
interleaved to improve performance (see step 1).
DIMM Installation (See Figure 2-2)
1. Insert the desired number of DIMMs into the memory slots, starting with
Bank 1.
modules at a time, beginning with Bank 1, then Bank 2, and so on.
2. Insert each DIMM module vertically into its slot.
notch along the bottom of the module to prevent inserting the DIMM
module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Memory Support
The motherboard only supports ECC registered DDR-266/200 MHz SDRAM
memory. If you are using 533 MHz front side bus processors(s), you must
use DDR-266 SDRAM.
processors(s), you may use either DDR-266 or DDR-200 SDRAM.
Figure 2-2.
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the
alignment
notch at the
bottom.
To Remove:
Use your
thumbs to
gently push
near the edge
of both ends
of the module.
This should
release it
from the slot.
The memory scheme is interleaved so you must install two
If you are using 400 MHz front side bus
Installing and Removing DIMMs
2-5
Chapter 2: Installation
Pay attention to the