Basic Operations; Understanding Gxw Voice Prompts; Table 5: Definitions Of The Table 6: Call Features Table - Grandstream Networks GXW400x User Manual

B O
ASIC PERATIONS
U GXW V
NDERSTANDING
GXW400x has a stored voice prompt menu for quick browsing and simple configuration. To enter the
voice prompt menu, press *** on the standard analog phone connected to any FXS port.
T 5: D
ABLE EFINITIONS OF THE
Menu Voice Prompt
Main Menu "Enter a Menu Option"
01 "DHCP Mode", "PPPoE Mode
"or "Static IP Mode"
02 "IP Address " + IP address
03 "Subnet " + IP address
04 "Gateway " + IP address
05 "DNS Server " + IP address
07 Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP Address
14 Configuration Server IP
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
99 "RESET"
"Invalid Entry"
Grandstream Networks, Inc.
P
OICE ROMPTS
GXW V P
OICE ROMPTS
User's Options
Enter "*" for the next menu option
Enter "#" to return to the main menu
Enter 01 – 05, 07,10 - 17, 47, 86 or 99 Menu option
Enter '9' to toggle the selection
If user selects "Static IP Mode", user need configure all the IP
address information through menu 02 to 05. If user selects
"Dynamic IP Mode", the device will retrieve all IP address
information from DHCP server automatically when user reboots
the device.
The current WAN IP address is announced
Enter 12-digit new IP address if in Static IP Mode.
Same as Menu option 02
Same as Menu option 02
Same as Menu option 02
Enter "9" to go to the next selection in the list:
•
•
•
•
•
•
Announces the Mac address of the unit.
Enter "9" to toggle between enable and disable
Announces current Firmware Server IP address. Enter 12 digit
new IP address.
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
Upgrade protocol for firmware and configuration update. Enter "9"
to toggle between TFTP and HTTP
Firmware version information.
Firmware upgrade mode. Enter "9" to rotate among the following
three options:
1.
2.
3.
Enter the target IP address to make a direct IP call, after dial
tone. (See "Make a Direct IP Call".)
Enter "9" to reboot the device; or
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to Main Menu
GXW400x User Manual
Firmware 1.0.0.67
PCM U
PCM A
iLBC
G-726
G-723
G-729
always check
check when pre/suffix changes
never upgrade
Page 10 of 35
Last Updated: 10/2007