Basic Operations; Understanding Gxw Voice Prompts; Table 5: Definitions Of The Gxw Voice Prompts - Grandstream Networks GXW40XX User Manual

B O
ASIC PERATIONS
U GXW V
NDERSTANDING
GXW40XX has a built-in voice prompt menu for simple device configuration. To enter the voice prompt
menu, press *** on the standard analog phone connected to any FXS port.
T 5: D
ABLE EFINITIONS OF THE
Menu Voice Prompt
Main Menu "Enter a Menu Option"
01
"DHCP Mode", "PPPoE
Mode "or "Static IP Mode"
02
"IP Address " + IP address
03 "Subnet " + IP address
04 "Gateway " + IP address
05
"DNS Server " + IP address
07
Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP
Address
14 Configuration Server IP
Address
15
Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
71-78
Phone calls between
different ports of the same
GW 400x
701-724 Phone calls between
different ports of the same
GW4024
86 Voice Mail
99 "RESET"
Grandstream Networks, Inc.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
P
OICE ROMPTS
GXW V P
OICE ROMPTS
User's Options
Enter "*" for the next menu option
Enter "#" to return to the main menu
Enter 01 – 05, 07,10 - 17, 47, 86 or 99 Menu option
Enter '9' to toggle the selection
If user selects "Static IP Mode", user need configure all the IP
address information through menu 02 to 05. If user selects
"Dynamic IP Mode", the device will retrieve all IP address
information from DHCP server automatically when user reboots
the device.
The current WAN IP address is announced
Enter 12-digit new IP address if in Static IP Mode.
Same as Menu option 02
Same as Menu option 02
Same as Menu option 02
Enter "9" to go to the next selection in the list:
•
PCM U
•
PCM A
•
iLBC
•
G-726
•
G-723
•
G-729
Announces the Mac address of the unit.
Enter "9" to toggle between enabled and disabled
Announces current Firmware Server IP address. Enter 12 digit
new IP address.
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
Upgrade protocol for firmware and configuration update. Enter
"9" to toggle between TFTP and HTTP
Firmware version information.
Firmware upgrade mode. Enter "9" to rotate among the following
three options:
1. always check
2. check when pre/suffix changes
3. never upgrade
Enter the target IP address to make a direct IP call, after dial
tone. (See "Make a Direct IP Call".)
Applies to GXW4004/GXW4008. User can make internal calls
between different ports inside the same GW even without being
registered to SIP server. By dialing *** and 7x user can reach
colleague connected to port "x".
Applies to GXW4024. User can make internal calls between
different ports inside the same GW even without being registered
to SIP server. By dialing *** and 7xx user can reach colleague
connected to port "xx".
Number of voice mails
Enter "9" to reboot the device; or
GXW40XX User Manual
Firmware 1.0.4.2
Page 11 of 38
Last Updated: 06/2011