Tonearm Mounting - Clearaudio Ambient User Manual

Ambient
User manual

4 Tonearm mounting

4.1 Unify mounting
To mount the tonearm base to the Ambient armboard, please use the screws without
nuts (M4x20) and place it like the red marked screws.
Pic. 10: Mounting the tonearm base
Once the
Carefully remove the security zip tie and unwrap the arm tube. Caution:
security zip tie is removed not to inadvertently pull it out of the armwand.
Place the arm tube on to the pivot point and lock it into it´s arm rest. Use the cable
strain relief screw (M4x10) and washer (red marked screw in the picture below) to
secure the cable to the tonearm base.
Pic. 11: Mounting the tonearm
Insure that the distance from the spindle to the pivot point of the tonearm is exactly 222
mm. Moving the armboard in one direction or another will allow you to locate the correct
position. Once located, tighten the armboard down. Shown in the picture below. You can
also use the optional clearaudio cartridge alignment gauge.
Seite 12  clearaudio electronic GmbH 2008