Whirlpool Cabrio WED6200S User Manual page 94

DIAGNOSTIC: Displaying Line Voltage
Used to display the line voltage currently be-
ing measured by the machine control:
After all saved fault codes have been dis-
played, press the Cycle Signal button. The
last 2 digits of the voltage value will be dis-
played on the dual 7-segment display.
A Dryness modifier LED will also be illuminat-
ed to indicate the voltage range corresponding
to the number displayed. The Dryness LEDs
relate to specific voltage ranges as follows:
• The More LED will be illuminated for high
voltage readings (above 132 VAC).
• The Normal LED will be illuminated for nor-
mal voltage readings (90-132 VAC).
• The Less LED will be illuminated for low
voltage readings (below 90 VAC).
DEACTIVATING THE DIAGNOSTIC
TEST MODE
Press the Pause/Cancel button twice to exit
diagnostics.
ACTIVATING THE MANUAL LOAD TEST
1. Be sure the dryer is in standby mode
(plugged in with all indicators off, or with
only the Clothes Dry indicator on).
2. Select any one button (except Pause/Can-
cel) and follow the steps below, using the
same button (remember the button):
Press/ Release Press/
hold 2-5 for 2-5 hold 2-5
seconds seconds seconds
88 flashes momentarily, the motor starts right
away, and the Heavy Duty LED flashes (this
step starts the Manual Load sequence):
1. Turn on motor.
Now press any key (except Pause/Cancel)
and the control will advance through each
step of the following sequence:
2. Motor + heater.
3. No loads on (motor + heater off).
4. Repeat using same button.
DEACTIVATING THE
MANUAL LOAD TEST
Press the Pause/Cancel button to exit this
mode.
6-20
Release Press/ Release
for 2-5 hold 2-5 for 2-5
seconds seconds seconds
Flash "Heavy Duty" LED.
Flash "Casual" LED.
Flash "Normal" LED.
Start sequence again at 1.
Press/
hold 2-5
seconds