Whirlpool Cabrio WED6200S User Manual page 77

Power button controls
Status indicators at right.
Rotating knob turns
indicators on or off.
"Less Time" button "More Time" button
turns the right digit of turns the left digit of
the display on or off. the display on or off.
Figure 2. Console Diagnostics.
DIAGNOSTIC: Door Switch
Opening the door should cause a beep and
an alphanumeric number to be displayed.
Closing the door should cause a beep and 88
to be displayed.
• If opening the door fails to cause a beep
and a number and letter to be displayed,
go to TEST #7.
DIAGNOSTIC: Moisture Sensor
Open the door and locate two metal strips on
the inside of the dryer. Bridge these strips with
a wet cloth or a finger.
• If a continuous beep tone is heard and an
alphanumeric number is displayed on the
console, the sensor is OK.
• If not, or if a continuous beep tone is heard
before bridging the moisture strips, go to
TEST #5.
Dryness button controls Temperature button controls
CONSOLE DIAGNOSTICS
all indicators above button. all indicators above button.
DIAGNOSTIC: Motor, Heater,
And Console ID
Close the door. Press the Start button. The
motor and heater will turn on, and the display
will show one of the following console IDs: C0,
C1, C2, C3, C4, C5, C6, C7, C8, or C9.
• If none of the Console IDs above are dis-
played, replace the user interface assem-
bly. See Accessing & Removing the Elec-
tronic Assemblies.
• If the motor does not turn on, go to TEST #3.
• If no heat is detected, go to TEST #4.
6-3
Start button turns on dryer.
Each button controls Turns off all indicators and
its own indicator. exits diagnostic mode.