Removing The Moisture Sensor And Metal Oxide Varistors (Movs) - Whirlpool Cabrio WED6200S User Manual

REMOVING THE MOISTURE SENSOR AND
METAL OXIDE VARISTORS (MOVS)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Open the dryer door.
4. To remove the moisture sensor:
a) Remove the screw and unhook the
sensor from the drum.
b) Disconnect the two wire connectors
from the moisture sensor.
Moisture Sensor
Strips Holder
Screw
5.
Moisture Sensor
Wire Connectors
4-17
To remove the metal oxide varistors
(MOVs):
a) Raise the lint screen lid and remove
the two screws from the top of the lint
screen air duct.
Lint Screen Lid
Top Duct Screws
b) Pull the dryer out from the wall so that
you can access the rear panel.
c) Remove the nine hex-head screws
from the rear panel and remove the
panel.
Rear Panel
Screws (1 of 9)
Continued on the next page.