Starting The Dryer - Whirlpool Cabrio WED6200S User Manual

STARTING THE DRYER

This manual covers several different models.
Your dryer may not have all of the cycles and
features described.
Follow these basic steps to start your dryer.
Please refer to specific sections of this manual
for more detailed information.
1. Clean lint screen before each load.
2. Place laundry into dryer and shut door.
3. Press POWER.
4. Turn the knob to the selected cycle. The
preset settings for Automatic Cycles or
Timed Cycles will illuminate. The estimated
(automatic cycle) or actual (Timed) cycle
time (in minutes) will show in the display.
NOTE: A default time is displayed when an
automatic cycle is selected. During the first
few minutes of the drying process, the cycle
time may automatically vary from the default
time based on the size and fabric type of the
load. Toward the end of the drying process,
the estimated time display will adjust again,
showing the final drying time.
To use an automatic cycle
• Press POWER.
• Turn the knob to desired Automatic Cycle.
• Select DRYNESS to adjust how dry you
want the load. As the cycle runs, the control
senses the dryness of the load and adjusts
the time automatically for the selected dry-
ness level.
The default dryness setting is Normal when
an Automatic Cycle is selected. You can
select a different dryness level, depend-
ing on your load, by pressing Dryness and
choosing More, Less or Damp. Selecting
More, Less or Damp automatically adjusts
the sensed time needed. Once a dryness
level is set, it cannot be changed without
stopping the cycle.
• Select the desired Options.
To make changes during an Automatic
Cycle:
• Press PAUSE/CANCEL.
• Adjust Dryness.
NOTE: Dryness selections can be made
only while using Automatic Cycles.
How the Accelercare
System Works
Moisture-sensing strips and temperature sen-
sors inside the dryer drum monitor how fast the
load is drying, how hot the air should be and
when clothes are dry. The system automatically
stops the cycle to help save time and avoid
overdrying.
To use a Timed Cycle
• Turn knob to desired Timed Cycle.
• Press the TIME ADJUST up or down arrows
until the desired drying time is displayed.
Press the up or down arrows and the time
will change by 1-minute intervals. Press and
hold the up or down arrows and the time will
change by 5-minute intervals.
NOTE: The Time Adjust features can be
used only with Timed Cycles.
• Press TEMP until the desired temperature
illuminates.
NOTE: The Temp feature can be used only
with Timed Cycles.
3-2
Drying
™