Whirlpool Cabrio WED6200S User Manual page 19

3. Connect ground wire (green or bare) of
direct wire cable to external ground con-
ductor screw. Tighten screw.
A
B
C
A. External ground conductor screw
B. Ground wire (green or bare) of power supply cord
C. ¾" (1.9 cm) UL listed strain relief
D. Center silver-colored terminal block screw
E. Neutral ground wire
F. Neutral wire (white or center wire)
4. Place the hooked ends of the other di-
rect wire cable wires under the outer ter-
minal block screws (hooks facing right).
Squeeze hooked ends together. Tighten
screws.
5. Tighten strain relief screw.
6. Insert tab of terminal block cover into slot
of dryer rear panel. Secure cover with
hold-down screw.
7. You have completed your electrical con-
nection. Now go to "Venting Require-
ments."
3-wire connection: Power supply cord
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
B
A
D
C
E
A. 3-wire receptacle (NEMA type 10-30R)
B. 3-wire plug
F
C. Neutral prong
D. Spade terminals with upturned ends
E. ³⁄ " (1.9 cm) UL listed strain relief
4
F. Ring terminals
G. Neutral wire (white or center wire)
1. Loosen or remove center silver-colored
terminal block screw.
2. Connect neutral wire (white or center
wire) of power supply cord to the center,
silver-colored terminal screw of the ter-
minal block. Tighten screw.
A
B
A. External ground conductor screw
B. Neutral ground wire
C. Center silver-colored terminal block screw
D. Neutral wire (white or center wire)
³⁄
E. " (1.9 cm) UL listed strain relief
4
3. Connect the other wires to outer terminal
block screws. Tighten screws.
2-11
E
D
G
C
D
E
F