Account/Codec Settings; Firmware Version 1.0.1.27 - Grandstream Networks GXV3240 Administration Manual

SIP T2 interval
Remove OBP from route
Check Domain Certificate
Enable SCA (Shared Call
Appearance)
Enable BargeIn
Auto-filling Pickup Feature
Code
Pickup Feature Code
Line-seize Timeout

ACCOUNT/CODEC SETTINGS

DTMF
DTMF Payload Type
Preferred Vocoder

Firmware Version 1.0.1.27

SIP T2 Interval (in seconds). The default setting is 4 sec.
Configures to remove outbound proxy from route. This is used for the
SIP Extension to notify the SIP server that the device is behind a
NAT/Firewall. The default setting is "No".
Choose whether the domain certificates will be checked or not when
TLS/TCP is used for SIP Transport. The default setting is "No".
If set to "Yes", the Shared Call Appearance (Broadsoft Standard) will be
used for the registered account. The default setting is "No".
If set to "Yes", the user could barge into an active call on a shared line.
The default setting is "No".
If set to "Yes", the "Pickup Feature Code" configured in web UI will be
automatically filled in on the phone's dial pad when picking up the
parked call. The default setting is "Yes". This option is used when
"Special Mode" is set to "Broadsoft" and "Enable SCA" is set to "Yes".
Configure the pickup feature code for call park. If "Auto-filling Pickup
Feature Code" is set to "Yes", this pickup feature code will be
automatically filled in on the phone's dial pad when picking up the
parked call. This option is used when "Special Mode" is set to
"Broadsoft" and "Enable SCA" is set to "Yes".
For Shared Call Appearance, phone must send a SUBSCRIBE request
for the line-seize event package whenever a user attempts to take the
shared line off hook. "Line Seize Timeout" is the line-seize event
expiration timer. The default value is 15 seconds. The valid range is from
15 to 60.
This parameter specifies the mechanism to transmit DTMF digits. There
are 3 supported modes: in audio which means DTMF is combined in the
audio signal (not very reliable with low-bit-rate codecs), via RTP
(RFC2833), or via SIP INFO. The default setting is "RFC2833".
This parameter sets the payload type for DTMF using RFC2833. Default
is 101. The valid range is from 96 to 127.
5 different vocoder types are supported on the phone, including G.711
A-law (PCMA), G.711 U-law (PCMU), G.722, G.726-32 and iLBC. Users
can configure vocoders in a preference list that is included with the same
preference order in SDP message. Arrange your preferred vocoder
GXV3240 Administration Guide Page 40 of 76