Firmware Version 1.0.1.27 - Grandstream Networks GXV3240 Administration Manual

Refer-To Use Target Contact
Auto Answer
Send Anonymous
Anonymous Call Rejection
Call Log
Special Feature
Feature Key Synchronization
Enable Call Features
No Key Entry Timeout (s)
Ring Timeout (s)
Transfer on 3-way Conference

Firmware Version 1.0.1.27

NOTE: In some cases where the user wishes to dial strings such as
*123 to activate voice mail or other applications provided by their service
provider, the * should be predefined inside the dial plan feature. An
example dial plan will be: { *x+ } which allows the user to dial * followed
by any length of numbers.
If set to "Yes", the "Refer-To" header uses the transferred target's
Contact header information for attended transfer. The default setting is
"No".
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep. If set to "Enable
Intercom/Paging", it will answer the call based on the SIP info header
sent from the server/proxy. The default setting is "No".
If set to "Yes", the "From" header in outgoing INVITE messages will be
set to anonymous, essentially blocking the Caller ID to be displayed.
The default setting is "No".
If set to "Yes", anonymous calls will be rejected. The default setting is
"No".
Configures Call Log setting on the phone. You can log all calls, log
incoming/outgoing calls (missed calls will not be logged), or disable call
log. The default setting is "Log All".
Different soft switch vendors have special requirements. Therefore users
may need select special features to meet these requirements. Users can
choose from Standard, Broadsoft, CBCOM, RNK, China Mobile, ZTE
IMS, Mobotix, ZTE NGN, or Huawei IMS depending on the server type.
The default setting is "Standard".
This feature is used for Broadsoft call feature synchronization. When it's
enabled, DND, Call Forward features and Call Center Agent status can
be synchronized between Broadsoft server and phone. The default
setting is "Disabled".
If set to "Yes", the call features using star codes on the phone will be
supported locally. Otherwise, the feature code will need to be provided
from the server side. The default setting is "No".
Defines the timeout (in seconds) for no key entry. If no key is pressed
after the timeout, the digits will be sent out. The default value is 4
seconds. The valid range is from 1 to 15.
Defines the timeout (in seconds) for the rings on no answer. The default
setting is 60. The valid range is from 10 to 300.
If set to "Yes", when the phone hangs up as the conference initiator, the
GXV3240 Administration Guide Page 44 of 76