Cleaning; Connecting The Phone - Snom 360 Manual

Installation
Adjusting the Position of the Display
The position of the snom360's display is adjustable up to an angle of
45° (Fig. 9 and 10).
Hold down the phone with one hand and adjust the display with your
other hand. Do not use too much force and do not pull, wrench, or twist
the display as this might damage or break the hinges.

Cleaning

To clean the snom360, use an anti-static cloth. Please avoid cleaning
liquids as they might damage the surface or internal electronics of the
phone.

Connecting the phone

First connect one end of the handset cable to the handset and then to
the jack labelled "
Next plug the Ethernet (network) cable into the RJ45 connector labelled
" ", and plug the other end into the network side to establish a data
link. The second RJ45 connector, labelled "
further Ethernet devices without the need for a second Ethernet
connection line.
If you are using an external power supply, please insert the plug of the
power supply into the connector labelled "
hook up the casing into the mains.
If you want to use a headset, it can be connected to the audio jack
labelled "
Clip the cords into the appropriate slots on the footstand or, in the case
of the handset cord, on the bottom shell of the phone (see Fig. 1 in the
chap. Setting up the phone).
12
Fig. 9
" on the left-hand side of the phone's bottom.
" on the bottom side of the snom 360.
Fig. 10
", is for daisy-chaining
" next to the data line and