Setup Software Update; Bootloader; Firmware; Status - Snom 360 Manual

Settings

Setup Software Update

MANUAL SOFTWARE UPDATE
Here you can select the firmware files to be put on the phone yourself.
This section may look like:

Bootloader

Specify the URL for the bootloader file (-b) you would like to place on
the phone through this setting. Because the bootloader will not change
at all, this field is not really needed!

Firmware

Similarly, you can provide the firmware (-l, -r, -j) URL in this setting.
Press the "Load" button if you changed something in these settings and
the phone would like to load the binary files through the newly provided
addresses.
The phone is showing "SW" and is then rebooting after a couple of
seconds. If it is showing "SW", but is not rebooting, please reboot the
phone by yourself.
Naming convention of the different images:
Bootloader "-b" is the bootloader and is doing not really much. We are
not expecting, that here will be much change.
Linux "-l" consist out of the linux kernel. Will change rarely only.
Ramdisk "-r" is the ramdisk which consists out of the fundamental files
which have to be there to get the linux system running. And with 3.14
we have added a small application which is able to upate all here
mentioned partitions via TFTP. Will change rarely only.
Application Filesystem (JFFS2) "-j", here we have the application which
is
performing as "phone". This is what usually will be updated.

Status

System Information
85