Configuring Ha / Pdsn Gy Interface Support - Cisco ASR 5000 Administration Manual

Gy Interface Support
context <context_name>
Notes:
 For information on configuring IP access lists, refer to the Access Control Lists chapter in the System
Administration Guide.
 For more information on configuring ECS ruledefs, refer to the ACS Ruledef Configuration Mode Commands
chapter in the Command Line Interface Reference.
 For more information on configuring ECS charging actions, refer to the ACS Charging Action Configuration
Mode Commands chapter in the Command Line Interface Reference.
 For more information on configuring ECS rulebases, refer to the ACS Rulebase Configuration Mode Commands
chapter in the Command Line Interface Reference.

Configuring HA / PDSN Gy Interface Support

To configure HA / PDSN Gy interface support, use the following configuration:
configure
context <context_name>
OL-27210-02
diameter dictionary <dictionary>
failure-handling initial-request continue
failure-handling update-request continue
failure-handling terminate-request continue
exit
exit
apn <apn_name>
selection-mode sent-by-ms
ims-auth-service <service>
ip access-group <access_list_name> in
ip access-group <access_list_name> out
ip context-name <context_name>
active-charging rulebase <rulebase_name>
credit-control-group <cc_group_name>
end
diameter endpoint <endpoint_name>
Cisco ASR 5000 IP Services Gateway Administration Guide ▄
Configuring Gy Interface Support ▀
135