To Cut And Unload A Plot From A Roll - HP Designjet 350C User Manual
Hewlett-packard designjet plotters user's guide
Hide thumbs
Also See for Designjet 350C:
- Service manual (268 pages) ,
- User manual (184 pages) ,
- Service manual (12 pages)
Table of Contents
Advertisement
Working with media
Unloading media
To cut and unload a plot from a roll
If the roll-feed option is installed, your plotter includes a built-in cutter. You may
choose to cut the roll between plots, or at the end of a series of plots, as explained
here.
There are two alternative plotting modes:
In Continuous Plotting mode, when you are cutting the roll after the last of a
C A U T I O N
series of plots, another plot sent to the plotter could start printing while you
are cutting. If this is likely, Pause mode, rather than Continuous Plotting
mode, is recommended.
To switch between the two modes,
press the
time, except when it has paused and is
waiting for you to cut a plot from the
roll.
While the plotter is in Continuous
Plotting mode, the
Pause mode. The plotter pauses between plots for you to cut the plot from the
roll (the default mode).
Continuous Plotting mode. The plotter does not pause between plots.
Continue Plotting
Roll
light flashes.
key at any
Continue
Plotting
Roll
2–29
Advertisement
Table of Contents
