HP Designjet 350C User Manual page 113

13
From the upgrade kit, take the
new overlay for the front panel.
1 Peel the adhesive layer from
the back.
2 Fix it over the top of the old
front panel.
14 Switch ON the plotter.
15 From the upgrade kit, take the three new colored cartridges (yellow, cyan and
magenta) and, together with the black cartridge you removed earlier, install them in
the plotter's four vacant cartridge stalls. This procedure is explained in full from
page 7–5 — remember to follow the instructions for the 350C, not the 330! Be
sure to match the colors of the cartridges with the colors of the dots.
16 Print a Setup Sheet to confirm that the plotter has correctly read the new ROM
SIMM and has reconfigured itself to be an HP DesignJet 350C For instructions on
how to print a Setup Sheet, see the section "Configure the plotter" starting on page
1–19. The place to look is at the top of the setup sheet, which should now read
"HP DesignJet 350C".
17 Finally, reconfigure the print driver(s) you are using to indicate that your device is
no longer an HP DesignJet 330 plotter, but now an HP DesignJet 350C plotter.
Drivers for AutoCAD and for Microsoft Windows applications are supplied as part
of your upgrade kit.
Reconfiguring your plotter Reconfiguring your plotter
To upgrade the HP DesignJet 330 with color To upgrade the HP DesignJet 330 with color
1
2
1915
6–11