If Media Crumples When You Load It; If Plots Do Not Feed Out Properly From The Plotter; If The Automatic Cutter Does Not Cut Immediately When A Plot Has Finished - HP Designjet 700 User Manual

If Media Crumples When You Load it

Clear any obstructions in the media path.
Be sure the leading edge is straight and free of tears. Cut a straight edge with
the knife if necessary.
If your media is curled, and if both sides are the same, load it with the curved
(hollow) side towards you (Certain media types – for example coated paper –
have a plotting side and a non-plotting side and these must be loaded plotting
side down.)
When loading media, hold each edge and push the media into the plotter evenly
against the stops until a slight buckle develops evenly across the media. Let go
as soon as it starts to feed into the plotter.
If you have just moved the plotter or your media from an environment with a
different humidity level, let the media stabilize for at least 15 minutes before
loading it.
Roll media only. Open the roll cover and raise the lever. Unload the leading
edge of the roll. Push the media all the way to the right so that it is flush against
the media stop on the roll core. Then reload the media.

If Plots Do Not Feed Out Properly From the Plotter

Make sure the roll cover is completely closed before you plot.
If The Automatic Cutter Does Not Cut Immediately When a Plot
Has Finished
Check the Page format / Margins
waits until the next plot begins plotting so it can create a 10 mm margin
between both plots or nesting sets.
Press the Form Feed and Cut
ink-drying time has passed or before the next plot begins plotting. Use caution
to avoid smearing the ink.
Check the ink-drying time and change if necessary (
Solving Media-Handling Problems
setting. When this is set to
key if you need to cut the media before the
Device setup / Drying time
Troubleshooting
Smaller , the plotter
).
9-5