HP Designjet 350C User Manual page 62

Working with media
Loading roll media
4 Make sure the entire leading edge of the roll – left and right – is placed inside the
entry slot.
5
IMPORTANT. While keeping the right-hand side aligned with the line of
holes, push the media in one swift and decisive movement up into the entry
slot. Try to keep the angle of the sheet the same as the angle of the slot.
Three things will happen in quick succession:
1 You will feel the media come up against the media stops.
2 The media may buckle slightly, as you are still pushing it. This is normal.
3 The plotter will start to take the media from you.
At this point, let go!
Don't touch the media while the plotter feeds it out again a short way, as this
would probably misalign it.
2–22
1923