Konica Minolta bizhub 362 User Manual page 166

5
5
Touch the one-touch dial button to
be registered.
– Touch an Index tab or [Index
List], then the desired one-touch
dial button.
– If the machine is set to allow
LDAP searches, a screen
appears, allowing you to permit
or prohibit the address registered
with the one-touch dial button to be found with an LDAP search. If
LDAP searches are not to be allowed, select "No".
6
Type in the destination name that will
appear on the one-touch dial button,
and then touch [Next].
7
Select the communication mode.
Touch [PC], [FTP], then [Next].
– If mode 476 of the software
switch settings was changed,
only communication modes that
can be selected appear. For
details, refer to "Specifying
software switch settings
(machine functions)" on
page 10-28.
8
Enter the upload destination host
address, and then touch [Next].
– To specify the host name, touch
[Host Name], and then touch
[Next].
– To change an entered address,
touch
cursor, or press the [C] (clear) key
to enter a new address.
5-26
or to move the
Scan to FTP
bizhub 362/282/222