3Com 3C840 User Manual page 63

Remote WAN IP Address:
If you were provided a remote IP address and netmask, select
I
Specified and type in that address and netmask.
If the OfficeConnect Remote 840 is learning the remote IP address
I
from the remote site (PPP only), select Learn from Remote.
2 In order to have the remote site you are configuring as the default
gateway, check the Use Remote as Default Gateway checkbox.
3 If you are routing IP traffic to multiple remote sites, select one to be your
default gateway. Then check this box only in the profile for that remote
site.
4 Select from the pull-down menu to have the RIP set to Broadcast, Listen,
or Broadcast & Listen, and if one of these is chosen, set the RIP option to
RIPV1 or RIPV2.
If you are using address translation (PAT / NAT), you must set routing to
either Listen or None. This is because you have set up a private network
and therefore do not want to be broadcasting information to other
routers.
5 Ensure that Enable IP is checked (enabled) and click Modify.
You are now done configuring the basic IP information for the Remote
Site Connection.
Further Remote Site IP Configuration information is available in the
following sections:
Address Translation information is available in
I
Translation Using the OfficeConnect Remote
Address Validation Information is available under
I
Validation".
Configuring IP for the Remote Site Connection 4-9
"Network Address
840".
"Using IP Address