9-4
C
9: C
HAPTER
ONFIGURING
Configure the
Remote Site IPX
Network Information
IPX R
OUTING
If you need to connect to multiple remote sites (i.e., two remote offices)
you can set up a remote site profile for each remote location.
For any routing to take place across the OfficeConnect Remote 840, you
also have to set up a corresponding network over the LAN. See
"Configuring IPX for the LAN"
The IPX configuration for the remote site begins at the IPX Modify
screen.
These instructions assume you have already added a remote site profile. If
you need to add a remote site profile, see
Chapter 3 for details on adding a remote site profile.
1 Access this screen by going to the OfficeConnect Remote 840 "home
page." Select Configuration > Remote Sites (WAN).
2 Select a profile and click Modify. This will access the Remote Sites
General Modify screen.
3 Continue clicking Next to advance through the ATM Modify, IP Modify,
and IP Advanced Modify screens.
4 Click Next to proceed to the IPX Modify screen.
for details.
"Remote Site Management"
in
Need help?
Do you have a question about the 3C840 and is the answer not in the manual?