3Com 3C840 User Manual page 196

E-6 A E: C
PPENDIX ONFIGURATION
(N -S W
ON ETUP IZARD
If you want to run RIP, select from the pull-down menu to have the RIP
I
set to Broadcast, Listen, or Broadcast & Listen, and if one of these
is chosen, set the RIP option to RIPV1 or RIPV2.
Ensure that Enable IP is checked (enabled).
I
2 Press the Next button to proceed to the IP Advanced Modify screen. This
screen contains the following fields:
3 Check the Enable PAT button to use Port Address Translation (refer to
the Configuration Planning Table in Chapter 1 of the OfficeConnect
Remote 840 SDSL Router Install Guide to determine if PAT is to be
enabled).
You cannot use an unnumbered Local IP WAN Address and have PAT
enabled.
) O C R
OF THE FFICE ONNECT
840
EMOTE